Walk-In Door, 18" x 60"
Aviary Door with self closing latch and padlock provision.
Galvanized 18" x 60" steel door
Full length piano hinge on door
Choice of wire grid sizes (see grid options)
GRID OPTIONS:
1/2" x 3" x 12.5 Gauge (STANDARD): This is the standard grid which is suitable for most birds from the smallest finches to most macaws.
1" x 3" x 11.5 Gauge (HEAVY DUTY): This is a heavy duty grid which is required for confirmed wire chewers such as Mollucan cockatoos, green winged macaws, or hyacinth macaws.
Galvanized 18" x 60" steel door
Full length piano hinge on door
Choice of wire grid sizes (see grid options)
GRID OPTIONS:
1/2" x 3" x 12.5 Gauge (STANDARD): This is the standard grid which is suitable for most birds from the smallest finches to most macaws.
1" x 3" x 11.5 Gauge (HEAVY DUTY): This is a heavy duty grid which is required for confirmed wire chewers such as Mollucan cockatoos, green winged macaws, or hyacinth macaws.
Wingz Avian Products
$113.45
SKU
757
- Buy 6 for $98.75 each and save 13%
Allows safe, routine cage access to aviaries of all sizes.
Our factory built walk-in door is just the right size for safe access but not too big to allow or encourage escape. Designed to be installed by mounting to existing or new aviary mesh panels. The door knock-out is normally cut-in about 6" above the floor. This places the top of the door about 5'-6". The keeper can safely access the doorway by stepping over and stooping slightly through the doorway. This places the keeper's body in such a way to close off large gaps. The door is constructed with galvanized steel framing for strength and corrosion protection. It has an automatic gate latch with a padlock provision. A padlock or carabiner can be added for extra security. The size shown is based on the size of the knockout cut into the cage wire panel. The door jamb is approximately 2" larger and the door is approximately 14" smaller. Powder coat color options available. Attachment is accomplished with 10 self threaded screws and washers attached from the inside. A 5/16" hex nut driver or cordless bit are recommended.
Our factory built walk-in door is just the right size for safe access but not too big to allow or encourage escape. Designed to be installed by mounting to existing or new aviary mesh panels. The door knock-out is normally cut-in about 6" above the floor. This places the top of the door about 5'-6". The keeper can safely access the doorway by stepping over and stooping slightly through the doorway. This places the keeper's body in such a way to close off large gaps. The door is constructed with galvanized steel framing for strength and corrosion protection. It has an automatic gate latch with a padlock provision. A padlock or carabiner can be added for extra security. The size shown is based on the size of the knockout cut into the cage wire panel. The door jamb is approximately 2" larger and the door is approximately 14" smaller. Powder coat color options available. Attachment is accomplished with 10 self threaded screws and washers attached from the inside. A 5/16" hex nut driver or cordless bit are recommended.
| SKU | 757 |
|---|---|
| Weight | 22.150000 |
| Manufacturer | Wingz Avian Products |
| Height (inches) | 60 |
| Width (inches) | 18 |
Write Your Own Review
Related Products
Check items to add to the cart or
